| OSCILLATOR PRODUCTS |
|---|
| KS Electronics has the capabilities, experience and
production technique to meet your exacting oscillator requirements.
Some of the oscillators available in SMD packages. |
| TCXO |
VCXO |
|---|
- Up to 350 MHz in frequency.
- >+15 dBm output into 50 ohms.
- Freq. stability of +/- 1 ppm from -40 C to + 85 C.
- Low power consumption 250 mW typical.
- Low phase noise. Typical SSB phase noise is -140 dBc/Hz at 1 kHz offset.
Excellent noise floor -165/Hz dBc min.
- In house facility for the measurement of phase noise.
- Typical volume 2.5 cubic inch max.
- Typical aging of .5 ppm per. yr. max.
- External adjustment of frequency available for 10 year
aging.
|
- Up to 350 MHz in frequency.
- Crystal controlled stability over full military range.
- Wide band tunning range +/- 2500 ppm pulling range with excellent temp. stability
of +/- 5 ppm from -30 C to +85 C.
- Linearity of +/- 2 % over the tunning range of V +/- 10 volts.
- +Ve or -Ve tunning slope available.
- Excellent short term stability and phase noise.
- Low input power and small volume ( 2.5 cubic inch max).
- External mechanical or electrical adjustment of frequency
available.
|
| DCXO |
VC-TCXO |
|---|
|
|
| OCXO |
VCO |
|---|
- We have standard OCXO at 10 MHz with second optional output at 5 MHz.
- Excellent temp. stability. .02 ppm -10 C to +55 C,
.05 ppm -55 C to +60 C
- Input power less than .65 watt at -55 C.
less than .55 watt at + 25 C.
- Warm up time: less than 10 minutes for .002 ppm stability.
- Excellent phase noise -100 dBc/Hz at 100 hz offset.
- dBm +/- 3 dB into 50 ohms.
- Electrical tuning available for external adjustment of frequency.
- Up to 500 MHz
- +16 dBm output into 50 ohms.
- Excellent tunning linearity +/- 5 % max.
- Temp. stability of 25 ppm/deg. C.
- Low power consumption (400 mW typical ).
- Harmonics/spurious : -10 dBc/-60 dBc.
- Typical SSB phase noise of -100 dBc/Hz at 10 kHz offset from carrier.
- Full military temperature of -55 deg. C to + 105 deg. C.
- Input voltage sensitivity of less than 2000 ppm per volt.
| Crystal Filters |
L/C Filters |
|---|
- Wide variety of crystal filters from 1 MHz up to 500 MHz in assorted
customized bandwidth, selectivity and packages.
- Phase and amplitude matched sets.
- Flat group delay with excellent selectivity.
- Third order intermodulation intercept point of + 30 dBm with in band input signal
levels at 0.0 dBm.
- 70 MHz crystal filters 1.1 MHz BW. Low loss.
- Standard 10.7 MHz, 21.4 MHz , 45.0 MHz, 70 MHz two pole monolythic crystal
filters.
- m-derived crystal filters for steep selectivity.
- Single sideband crystal filters.
- Notch filters Wide BW-steep/deep notch.
- Up to 250 MHz
- Group delay equalized with excellent selectivity.
- Low pass , high pass , band rejects along with band pass version available.
- We also have resources to make helical resonators, filters. Helical resonator
filters are used where the crystal filters are not practical to make and the
requirements are too narrow for L/C filters.
| | | |